Follow the steps below to make this Easy Origami Yoda designed by Eric Ha.
Difficulty: Easy
Who doesn’t love Star Wars? If you’re a Star Wars fan, and of course you are, you’ll appreciate these easy origami Yoda instructions.
This Yoda comes with a stand that also doubles as his robe. It’s a cute origami model that’s just as cute as the adorable and huggable, but ugly Yoda. This origami Yoda is designed by myself.
Step 1: Start with a square piece of origami paper color side down. If you only have regular 8.5×11 paper, follow these instructions to make a square sheet. You can also use these colorful Printable Origami Paper.
Step 2: Fold the left half over to the right by folding the left corner to the right corner. Crease the fold well, and then unfold.
Step 3: Fold the bottom corner to the top corner.
Step 4: Grab both layers of the top corner and fold them down to the center of the bottom edge. The center is where the vertical crease is.
Step 5: Grab only the top layer and fold it up so that about half of the triangle will extend pass the top edge. See the image.
Step 6: Fold the tip down like this.
Step 7: Fold the left half at straight up at the center, and then do the same for the right half.
Step 8: Fold the top left edge to the center, and do the same for the top right edge.
Step 9: Fold Yoda’s ridiculously large ears down like this.
Step 10: Then fold his ears back up like this so that they point out to the side.
Step 11: Fold the chin up.
Step 12: Turn the paper over and draw his face.
Next, we will make the body and stand so that Yoda can stand on his own and look cute in his own ugly way on your desk.
Step 13: Get out another piece of square origami paper and place it color side up.
Step 14: Fold the left half to the right, then unfold.
Step 15: Fold the top left and right edges to the center, but at a slight angle like in the pictures.
Step 16: Fold the bottom left and right edges to the center.
Step 17: Turn the paper over.
Step 18: Fold the bottom corner to the top corner.
Step 19: Fold the top corner to the bottom edge.
Step 20: Fold the top corner of the lower layer down like this.
Step 21: Turn the paper over.
Step 22: Fold the left and right corners to the center.
Step 23: Turn the paper over.
Step 24: Slide Yoda’s head over the top of the body and turn the figure over again.
Click “Like” if you like this easy origami Yoda with stand!
Go to Next page to continue with the easy origami yoda instructions. Next, we will make the body and stand so that Yoda can stand on his own and look cute in his own ugly way on your desk.
